pulled and modded all 4 corners for a very aggressive setup. we will see what is to come for this ride.
ok here is how to modify that section that keeps rubbing past the bumper
1. detach bumper from by removing the 1 10mm bolt that holds the assembly together, I like to use a micro fiber towel to keep the bumper away from the body panel.
2. using metal cutting sheers I cut a slit where the bumper meets the fender, heat well as if you were rolling fenders
than bang upwards and in using a rubber mallet. be very careful making sure that the mallet does not slip
3. repeat on other side
banner shot (thanks Noel)
Posted by AWDalbert at 2:12 PM